Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - SEAT BELT INDICATOR ALWAYS ON
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition off. Disconnect the Seat Belt Switch harness connector. Connect a jumper wire between cavity 1 and cavity 2.
NOTE:
For vehicles equipped with Seat Belt Pre- Tensioner, use the Wiring Diagrams as a guide to ensure proper terminal selection. Turn the ignition on. Observe the Seat Belt Indicator. Did the Seat Belt Indicator illuminate for approximately 4 seconds and turn off? Yes --> Replace the Seat Belt Buckle in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 2 |
All |
| 2 | Turn the ignition off. Disconnect the Seat Belt Switch harness connector. Measure the resistance between ground and the Seat Belt Switch Ground circuit. Is the resistance above 5.0 ohms? Yes --> Repair the Seat Belt Switch Ground circuit for an open. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 3 |
All |
| 3 | Turn the ignition off. Disconnect the Seat Belt Switch harness connector. Disconnect the Instrument Cluster harness connector. Measure the resistance of the Seat Belt Switch Sense circuit between the Seat Belt Switch connector and the Instrument Cluster connector. Is the resistance above 5.0 ohms? Yes --> Repair the Seat Belt Switch Sense circuit for an open. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Instrument Cluster in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |