LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: *PRND OR AUTOSTICK INDICATOR INACCURATE OR INOPERATIVE >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - PRND OR AUTOSTICK INDICATOR INACCURATE OR INOPERATIVE

TEST ACTION APPLICABILITY
1
NOTE: Ensure that the correct Instrument Cluster is installed and is correctly configured for the vehicle.
NOTE: Ensure that there is communication between the MIC, PCM, and the TCM before proceeding with this test.
NOTE: Diagnose and repair any DTCs before proceeding with this test.
NOTE: Ensure that the TCM passes the Shift Lever Test with the DRBIII® before proceeding with this test.
Turn the ignition on.With the DRBIII®, read DTCs.Does the DRBIII® display any MIC, PCM, or TCM DTCs?Yes --> Perform appropriate test.Perform BODY VERIFICATION TEST - VER 1 .No --> Go To 2		 All
2 Perform the Instrument Cluster Self Test.
Turn the ignition off.
Press and hold the Trip Reset button.
Turn the ignition on.
Observe the PRND / AutoStick VF display during the Self Test.
Did any part of the VF display fail to illuminate?
Yes --> Replace the Instrument Cluster in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> The condition is not present at this time. Monitor DRBIII® parameters while wiggling the related wire harness. Refer to any Technical Service Bulletins (TSBs) that may apply. Visually inspect the related wiring harness and connector terminals.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals