Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - LOW FUEL WARNING INDICATOR NOT OPERATING PROPERLY
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
Ensure that there is communication between the PCM, BCM, and the Instrument Cluster before proceeding with this test. Perform the Instrument Cluster Self Test.Turn the ignition off.Press and hold the Trip/Reset button.Turn the ignition to the Unlock position.During the self test all Indicators should illuminate for approximately 4 seconds.Observe the Malfunction Indicator Lamp during the Self Test.Did the Malfunction Indicator Lamp Indicator illuminate for approximately 4 seconds then turn off?Yes --> Go To 2No --> Go To 3 |
All |
| 2 | Using the DRBIII® read DTC's. Are there any DTC's present? Yes --> Perform appropriate test for problems related to the DTC. Perform BODY VERIFICATION TEST - VER 1 . No --> The condition is not present at this time. Monitor DRBIII® parameters while wiggling the related wire harness. Refer to any Technical Service Bulletins (TSBs) that may apply. Visually inspect the related wiring harness and connector terminals. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 3 | Remove and inspect the Malfunction Indicator Lamp bulb and socket. Is there a problem with the bulb or socket? Yes --> Replace the Indicator bulb or socket as necessary in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Instrument Cluster in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |