Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - HIGH BEAM INDICATOR ALWAYS ON
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII® in Body Control Inputs/Outputs, read the Hi Beams state. Does the DRBIII® Inputs/Outputs, display On? Yes --> Go To 2 No --> Replace the Instrument Cluster in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 2 | Turn the ignition off. Disconnect the Multi- Function Switch harness connector. Turn the ignition on. With the DRBIII® in Body Control Inputs/Outputs, read the Hi Beams state. Does the DRBIII® display On? Yes --> Go To 3 No --> Replace the Multi- Function Switch in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 3 | Turn the ignition off. Disconnect the Multi- Function Switch harness connector. Disconnect the Junction Block C6 harness connector. Turn the ignition on. Measure the voltage between the Dimmer Switch High Beam Output circuit and ground. Is there any voltage present? Yes --> Repair the Dimmer Switch High Beam Output circuit between the Multi- Function Switch and the Junction Block for a short to voltage. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 4 |
All |
| 4 | Turn the ignition off. Disconnect the Junction Block C6 harness connector. Turn the ignition on. Measure the voltage between the #3 Fuse in the Junction Block and ground. Is there any voltage present? Yes --> Replace the Junction Block in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Body Control Module in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |