Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - FUEL GAUGE NOT OPERATING PROPERLY
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
Ensure that there is communication between the PCM, BCM, and the Instrument Cluster before proceeding with this test. Perform the Instrument Cluster Self Test.Turn the ignition off.
NOTE:
The Instrument Cluster will illuminate the Engine Coolant Temperature indicator at 124°C (255°F). The indicator will turn off at 121°C (250°F). Press and hold the Trip Reset button.Turn the ignition to the Unlock position.Release the Trip Reset button when the Self Test begins.Observe the Engine Coolant Temperature Warning indicator during the Self Test.Did the Engine Coolant Temperature indicator illuminate for approximately 4 seconds and then turn ofYes --> Go To 2No --> Go To 3 |
All |
| 2 | Turn the ignition on. Using the DRBIII® read DTC's. Are there any DTC's present? Yes --> Perform appropriate test related to DRIVEABILITY. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 3 |
All |
| 3 | Turn the ignition off. Remove the Engine Coolant Temperature Warning Indicator LED. Using a DVOM, select "Diode Mode" and connect the leads across the LED.
CAUTION:
Ensure that the RED lead is on the "+" of the LED. Did the Engine Coolant Temperature Warning Indicator LED illuminate? Yes --> Replace the Instrument Cluster in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Engine Coolant Temperature Warning Indicator LED in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |