LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: *CRUISE ENGAGED INDICATOR INOPERATIVE >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - ENGINE COOLANT TEMPERATURE GAUGE INOPERATIVE

TEST ACTION APPLICABILITY
1
NOTE: Ensure that the Junction Block Fuse #11 is not open. If the fuse is open make sure to check for a short to ground.
NOTE: Ensure that there is communication between the PCM, BCM, and the Instrument Cluster before proceeding with this test.
Perform the Instrument Cluster Self Test.Turn the ignition off.Press and hold the Trip Reset button.Turn the ignition to the Unlock position.Release the Trip Reset button when the Self Test begins.Observe the Cruise Indicator during the Self Test.Did the Cruise indicator illuminate for approximately 4 seconds and then turn off?Yes --> Go To 2No --> Go To 3
All
2 Start the engine.
Drive the vehicle.
Activate the Cruise system.
Does the Cruise system operate properly?
Yes --> Test Complete.
No --> Refer to CRUISE DIAGNOSTICS  for the related symptom(s).
Perform BODY VERIFICATION TEST - VER 1 .
All
3 Remove and inspect the Cruise Engaged Indicator Lamp bulb and socket.
Is the bulb or socket defective?
Yes --> Replace the Cruise Indicator bulb or socket as necessary in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Replace the Instrument Cluster in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
All