Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSTIC PROCEDURE - CRUISE ENGAGED INDICATOR INOPERATIVE

TEST	ACTION	APPLICABILITY
1	NOTE: Ensure that the Junction Block Fuse #11 is not open. If the fuse is open make sure to check for a short to ground. NOTE: Ensure that there is communication between the PCM, BCM, and the Instrument Cluster before proceeding with this test. Perform the Instrument Cluster Self Test.Turn the ignition off.Press and hold the Trip Reset button.Turn the ignition to the Unlock position.Release the Trip Reset button when the Self Check begins.Observe the Charging System Warning Indicator during the Self Test.Did the Charging System Warning Indicator illuminate for approximately 4 seconds and then turn off?Yes --> Go To 2No --> Go To 3	All
2	Using the DRBIII®, read DTC's. Are there any DTC's present? Yes --> Perform appropriate test. Perform BODY VERIFICATION TEST - VER 1 . No --> The condition is not present at this time. Monitor DRBIII® parameters while wiggling the related wire harness. Refer to any Technical Service Bulletins (TSBs) that may apply. Visually inspect the related wiring harness and connector terminals. Perform BODY VERIFICATION TEST - VER 1 .	All
3	Remove and inspect the Charging System Warning Indicator bulb and socket. Is the indicator bulb or socket defective? Yes --> Replace the Indicator bulb or socket as necessary in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Instrument Cluster in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 .	All