Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - ABS LAMP CIRCUIT
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
Ensure that the Junction Block Fuse #11 is not open. If the fuse is open make sure to check for a short to ground. Turn the ignition on.With the DRBIII®, record and erase DTC's.Turn the ignition off, wait 15 seconds, then turn the ignition on.With the DRBIII®, read DTCs.Did the Indicator Lamp Open or Short DTC reset?Yes --> Go To 2No --> Test Complete. |
All |
| 2 | Turn the ignition off. Remove and inspect the Indicator Bulb in question. Is the Indicator Bulb in question defective? Yes --> Replace the Indicator Bulb in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Instrument Cluster in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |