LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Heating & A/C >> Symptom: HEAD STATUS RX FAILURE - ATC >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - HEAD STATUS RX FAILURE - ATC

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIII®, record and erase Body Computer DTC's.
Cycle the ignition switch.
With the DRBIII®, read the Body Computer DTCs.
Does the DRBIII® display: Head Status RX Failure?
Yes --> Go To 2
No --> Go To 3		 All
2 Turn the ignition on.
With the DRBIII® in Automatic Temperature Control, Monitor Display, PCI Bus Info ATC, look for ATC Status Msg Pres.
Does the DRBIII® display: ATC Status Msg Pres: Yes?
Yes --> Replace the Automatic Temperature Control in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Replace and program the Body Control Module in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .		 All
3 Turn the ignition off.
NOTE: Visually inspect the related wiring harness and circuits. Look for any chafed, pierced, pinched, or partially broken wires.
NOTE: Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
NOTE: Refer to any Technical Service Bulletins (TSBs) that may apply.

Were any problems found?
Yes --> Repair as necessary.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Test Complete.		 All
scientia non olet · About LEMON Manuals