LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Heating & A/C >> Symptom: A/C BLEND DOOR INPUT SHORTED TO BATTERY - MTC >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - A/C BLEND DOOR INPUT SHORTED TO BATTERY - MTC

TEST ACTION APPLICABILITY
1 With the DRBIII®, record and erase Body Computer DTC's.
Turn the ignition off.
Disconnect the A/C - Heater Control C1 harness connector.
Turn the ignition on.
Measure the voltage of the Temperature Select Signal circuit.
Is the voltage above 0.3 volts?
Yes --> Go To 2
No --> Replace the A/C - Heater Control in accordance with the Service Information.
Calibration must be performed after repair/replacement is completed.
Perform BODY VERIFICATION TEST - VER 1 .		 All
2 Turn the ignition off.
Disconnect the A/C - Heater Control C1 harness connector.
Disconnect the Body Control Module C2 harness connector.
Turn the ignition on.
Measure the voltage of the Temperature Select Signal circuit.
Is there any voltage present?
Yes --> Repair the Temperature Select Signal circuit for a short to voltage.
Calibration must be performed after repair/replacement is completed.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Replace and program the Body Control Module in accordance with the Service Information.
Calibration must be performed after repair/replacement is completed.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals