LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Exterior Lighting >> Symptom: *HI BEAM HEADLAMPS WILL NOT TURN OFF >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - HI BEAM HEADLAMPS WILL NOT TURN OFF

TEST ACTION APPLICABILITY
1 Remove the Headlamp Delay Relay from the junction block.
Did the High Beam Headlamps turn off?
Yes --> Go To 2
No --> Repair the Headlamp Delay Relay Output Circuit for a short to voltage.
Perform BODY VERIFICATION TEST - VER 1 .		 All
2 Remove the Headlamp Delay Relay.
Measure the voltage of the Headlamp Delay Relay Control circuit in the relay connector.
Is the voltage above 1.0 volts?
Yes --> Go To 3
No --> Replace the Headlamp Delay Relay.
Perform BODY VERIFICATION TEST - VER 1 .		 All
3 Remove the Headlamp Delay Relay from the junction block.
Disconnect the Multifunction Switch connector.
Measure the voltage of the Switched Headlamp Delay Relay Control circuit to ground.
Is the voltage above 1.0 volts?
Yes --> Repair the Headlamp Delay Relay Control Circuit for a short to voltage.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Replace the Multifunction Switch.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals