LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Exterior Lighting >> Symptom: *HEADLAMP DELAY RELAY INOPERATIVE >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - HEADLAMP DELAY RELAY INOPERATIVE

TEST ACTION APPLICABILITY
1 Turn the ignition off.
Check the PDC fuse 4.
Is the fuse open?
Yes --> Replace the open Fuse.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 2
All
2 Turn the ignition on.
Measure the voltage of the Fused B+ Circuit between the PDC and the Junction Block.
Is the voltage above 10.0 volts?
Yes --> Go To 3
No --> Repair the Fuse B+ Circuit for an open condition.
Perform BODY VERIFICATION TEST - VER 1 .
All
3 Turn the ignition off.
Install a known good relay in place of the Headlamp Delay Relay.
Actuate the Headlamp Delay system.
Does the Headlamp Delay system operate normally?
Yes --> Replace the Headlamp Delay Relay.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 4
All
4 Turn the ignition on.
With the DRBIII®, read the Ignition Voltage.
Does the DRBIII® display voltage above 10.0 volts?
Yes --> Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1 .
No --> The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1 .
All