Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - PASSENGER DOOR AJAR CIRCUIT OPEN
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Open the passenger door. With the DRBIII® in Inputs/Outputs, read the PAS DR AJAR SW state. Does the DRBIII® display CLOSED? Yes --> The condition that caused this symptom is currently not present. Inspect the related wiring harness for a possible intermittent condition. Look for any chafed, pierced, pinched or partially broken wires. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 2 |
All |
| 2 | Disconnect the Passenger Door Lock Motor/Ajar switch connector. Using a 12-volt Test Light connected to 12-volts, test the Ground circuit for continuity. Does the light illuminate? Yes --> Go To 3 No --> Repair the Ground circuit for an open. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 3 | Disconnect the Passenger Door Lock Motor/Ajar Switch connector. With the DRBIII® in Inputs/Outputs, read the PAS DR AJAR SW state. Connect a jumper wire between the Sense circuit and the Ground circuit. Does the DRBIII® display PAS DR AJAR SW: CLOSED? Yes --> Replace the Passenger Door Lock Motor/Ajar Switch. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 4 |
All |
| 4 | Disconnect the Body Control Module C4 harness connector. Disconnect the Passenger Door Lock Motor/Ajar Switch harness connector. Measure the resistance of the Sense circuit. Is the resistance below 5.0 ohms? Yes --> Replace the Body Control Module. Perform BODY VERIFICATION TEST - VER 1 . No --> Repair the Passenger Door Ajar Switch Sense circuit for an open. Perform BODY VERIFICATION TEST - VER 1 . |
All |