LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Communication >> Symptom: BATTERY POWER TO MODULE DISCONNECTED >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - BATTERY POWER TO MODULE DISCONNECTED

TEST ACTION APPLICABILITY
1 Connect the DRB to the Data Link Connector.
Turn the ignition on.
With the DRB, erase BCM DTC's.
Turn the ignition off then turn the ignition on.
With the DRB, read BCM DTC's.
Did this DTC reset?
Yes --> Go To 2
No --> No problem found at this time. Use appropriate SYSTEM WIRING DIAGRAMS article to help isolate a possible intermittent wiring problem.
Perform BODY VERIFICATION TEST - VER 1 .		 All
2 Turn the ignition off.
Remove the BCM from the Junction Block.
Turn the ignition on.
Using a 12-volt test light connected to ground, probe the Fused B+ circuit in the Junction Block Body Control Module connector cavity 12.
Is the test light illuminated?
Yes --> Replace the Body Control Module in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Replace the Junction Block in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals