LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Communication >> Symptom: *NO RESPONSE FROM BODY CONTROL MODULE >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - NO RESPONSE FROM BODY CONTROL MODULE

TEST ACTION APPLICABILITY
1
NOTE: Make sure the DRB can communicate with other modules before proceeding, if not refer to the PCI BUS COMMUNICATION FAILURE SYMPTOM .
Turn the ignition off.Disconnect the BCM C1, C2 and C3 harness connectors.
NOTE: Ensure all lights are turned off.
Using a 12-volt test light connected to 12-volts, probe each ground circuit.Is the test light illuminated for each circuit?Yes --> Replace the Body Control Module in accordance with the service information.Perform BODY VERIFICATION TEST - VER 1 .No --> Repair the Ground circuit(s) for an open.Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals