Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - CHIME SOUNDS WITH DRIVERS DOOR OPEN AND KEY REMOVED FROM IGNITION
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Ensure all exterior lamps are off. With the DRB III select: Body Computer Input/Output. Remove the key from the ignition switch. Read the Key-In Ignition status. Does the DRB III show Key-In Ign: CLOSED? Yes --> Go To 2 No --> Replace the Body Control Module. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 2 | Turn the ignition off. Disconnect the Ignition Switch C3 harness connector. Disconnect the Body Control Module C1 harness connector. Measure the resistance of the Key-in Ignition Switch Sense circuit to ground. Is the resistance below 100.0 ohms? Yes --> Repair the Key-in Ignition Switch Sense circuit to ground. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 3 |
All |
| 3 | Disconnect the Ignition Switch C3 connector. With the DRBIII® select: Body Computer Input/Output. Read the Key-In Ignition Status. Does the DRBIII® display Key-In Ign CLOSED? Yes --> Go To 4 No --> Replace the Ignition Switch. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 4 | If there are no possible causes remaining, view repair. Repair Replace the Body Control Module. Perform BODY VERIFICATION TEST - VER 1 . |
All |