LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Chime >> Symptom: *CHIME INOPERATIVE WITH DRIVER SEAT BELT UNFASTENED >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - CHIME INOPERATIVE WITH DRIVER SEAT BELT UNFASTENED

TEST ACTION APPLICABILITY
1 Ensure the drivers seat belt is unfastened.
With the DRBIII®, select Electro Mech Cluster Input/Output.
Turn the ignition on.
Read the Seat Belt Sw status.
Does the DRBIII display Seat Belt Sw: Closed
Yes --> Go To 2
No --> Replace the Instrument Cluster.
Perform BODY VERIFICATION TEST - VER 1 .		 All
2 Disconnect the Seat Belt Switch connector.
With the DRBIII®, select Electro Mech Cluster Input/Output.
Turn the ignition on.
Read the seat Belt Sw status.
Does the DRBIII display Seat Belt Sw: Closed
Yes --> Go To 3
No --> Repair the Seat Belt switch pigtail wiring or replace the Buckle assembly.
Perform BODY VERIFICATION TEST - VER 1 .		 All
3 Turn the ignition off.
Removed the Instrument Cluster from the instrument panel.
Disconnect the Seat Belt Switch connector.
Measure the resistance between ground and the Seat Belt Switch Sense circuit.
Is the resistance below 100.0 ohms?
Yes --> Repair the Seat Belt Switch Sense wire for a short to ground.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 4		 All
4 If there are no possible causes remaining, view repair.
Repair
Replace the Instrument Cluster.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals