LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Airbag >> Symptom List: ACCELEROMETER 1; INTERNAL 1; INTERNAL 2; INTERNAL 3; INTERNAL 4; OUTPUT DRIVER 1; OUTPUT DRIVER 2; STORED ENERGY FIRING 1 >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - ACCELEROMETER 1

TEST ACTION APPLICABILITY
1 Turn the ignition on.
NOTE: Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be referred to as an ACM.

Select the appropriate module and DTC type combination:
ACM - ACTIVE DTC
Go To 2
ACM - STORED DTC
Go To 2
NOTE: When reconnecting Airbag system components, the ignition must be turned off and the battery must be disconnected.
 All
2
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND PERSONAL INJURY OR DEATH.
If there are no possible causes remaining, view repair.Repair:Replace the Airbag Control Module in accordance with Service Instructions.Perform AIRBAG VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals