LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Powertrain Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> DRIVEABILITY - NGC - Symptoms >> Symptom: *CHECKING PCM POWER AND GROUND CIRCUITS >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - CHECKING PCM POWER AND GROUND CIRCUITS

TEST ACTION APPLICABILITY
1
NOTE: The battery must be fully charged before continuing.
Turn the ignition off.Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMINALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Using a 12-volt test light connected to ground, probe the (A14) PCM Fused B+ circuit in the Pinout Box.Does the test light illuminate brightly?Yes --> Go To 2No --> Repair the (A14) Fused B+ circuit.Perform POWERTRAIN VERIFICATION TEST VER - 1 .		 All
2 Turn the ignition off.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMINALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.

Turn the ignition on.
Using a 12-volt test light connected to ground, probe the (A41) PCM Fused Ignition Switch Output circuit in the Pinout Box.
Does the test light illuminate brightly?
Yes --> Go To 3
No --> Repair the (A41) Ignition Switch Output circuit
Perform POWERTRAIN VERIFICATION TEST VER - 1 .		 All
3 Turn the ignition off.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMINALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.

Using a 12-volt test light connected to battery voltage, probe the (Z12) PCM ground circuits in the Pinout Box.
Does the test light illuminate brightly?
Yes --> Test Complete.
No --> Repair the (Z12) PCM ground circuits.
Perform POWERTRAIN VERIFICATION TEST VER - 1 .		 All
scientia non olet · About LEMON Manuals