LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Powertrain Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> DRIVEABILITY - NGC - Diagnostic Tests >> U110C-No Fuel Level Bus Message >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - U110C-NO FUEL LEVEL BUS MESSAGE

TEST ACTION APPLICABILITY
1
NOTE: If a fuel level circuit or performance DTC is set along with P1681, diagnose the circuit/performance DTC before continuing.
Turn the ignition on.With the DRBIII®, erase DTCs.Start the engine on and off several times. Leave the engine running for at least 20 second each time.With the DRBIII®, read DTCs.Does the DTC reset?Yes --> Go To 2No --> Refer to the INTERMITTENT CONDITION .Perform POWERTRAIN VERIFICATION TEST VER - 1 .
All
2 Ignition on, engine not running.
With the DRBIII®, attempt to communicate with the BCM.
Can communication be established with the BCM?
Yes --> Go To 3
No --> Refer to the COMMUNICATION CATEGORY  and perform the appropriate symptom related to no communication with BCM.
Perform POWERTRAIN VERIFICATION TEST VER - 1 .
All
3 Turn the ignition on.
Using the DRBIII®, read the Fuel Level parameter in the PCM.
Does the DRBIII® display a fuel level value?
Yes --> Replace and program the Powertrain Control Module in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 1 .
No --> Go To 4
All
4 Turn the ignition off.
Disconnect the PCM harness connectors.
Disconnect the BCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMINALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.

Measure the resistance of the PCI Bus circuit from the BCM harness connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
Yes --> Replace BCM in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 1 .
No --> Repair the PCI Bus circuit between the PCM and the BCM for an open.
Perform POWERTRAIN VERIFICATION TEST VER - 1 .
All