LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Powertrain Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> DRIVEABILITY - NGC - Diagnostic Tests >> P0630-VIN Not Programmed In Pcm >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS PROCEDURE - P0630-VIN NOT PROGRAMMED IN PCM

TEST ACTION APPLICABILITY
1 Ignition on, engine not running.
With the DRBIII®, erase DTCs.
Using the DRBIII®, program VIN into the PCM.
Start the engine.
NOTE: If the engine will not start, crank the engine over for 15 seconds. Crank at least 2 times with the ignition switch returning to the off position each time.

Allow the engine to reach normal operating temperature.
With the DRBIII®, read DTCs.
Does the DTC reset?
Yes --> Go To 2
No --> The VIN has been successfully programmed into the PCM. Test is complete.
Perform POWERTRAIN VERIFICATION TEST VER - 1 .		 All
2
NOTE: The ignition switch must be left in the off position for a minimum of 10 seconds.
Cycle the ignition switch to the off position and then back to run.Attempt to program the PCM with the applicable information.Start the vehicle and allow it to reach normal operating temperatures.With the DRBIII®, read DTCs.Does the DTC reset?Yes --> Replace and program the Powertrain Control Module in accordance with the Service Information.Perform POWERTRAIN VERIFICATION TEST VER - 1 .No --> The VIN has been successfully programmed into the PCM. Test is complete.Perform POWERTRAIN VERIFICATION TEST VER - 1 .		 All
scientia non olet · About LEMON Manuals