Section 111 (MULTIPORT Fuel Injection (MFI) 3.0L - Symptom Procedures - Coupe)
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication with Scan Tool Is Not Possible. (Communication with All Systems Is Not Possible.)
- INSPECTION PROCEDURE 2: Scan Tool Communication with ECM or PCM Is Not Possible.
- INSPECTION PROCEDURE 3: The Malfunction Indicator Lamp (SERVICE ENGINE SOON) Does Not Illuminate Right after the Ignition Switch Is Turned to the "ON" Position.
- INSPECTION PROCEDURE 4: The Service Engine Soon/Malfunction Indicator Lamp Remains Illuminated and Never Goes Out.
- INSPECTION PROCEDURE 5: Cranks, Won't Start
- INSPECTION PROCEDURE 6: Starts Up and Dies.
- INSPECTION PROCEDURE 7: Hard Starting
- INSPECTION PROCEDURE 8: Unstable Idle (Rough Idle, Hunting).
- INSPECTION PROCEDURE 9: Idle speed is high (improper idle speed).
- INSPECTION PROCEDURE 10: Idle Speed Is Low (Improper Idle Speed).
- INSPECTION PROCEDURE 11: When the engine is cold, it stalls at idle (die out).
- INSPECTION PROCEDURE 12: When the Engine Is Hot, It Stalls at Idle (Die Out).
- INSPECTION PROCEDURE 13: The Engine Stalls When Accelerating (Pass Out).
- INSPECTION PROCEDURE 14: The engine stalls when decelerating.
- INSPECTION PROCEDURE 15: Hesitation, sag or stumble.
- INSPECTION PROCEDURE 16: Acceleration shock.
- INSPECTION PROCEDURE 17: Deceleration Shock
- INSPECTION PROCEDURE 18: Poor acceleration.
- INSPECTION PROCEDURE 19: Surge.
- INSPECTION PROCEDURE 20: Knocking
- INSPECTION PROCEDURE 21: Dieseling.
- INSPECTION PROCEDURE 22: Too high CO and HC concentration when idling
- INSPECTION PROCEDURE 23: Transient, Mass Emission Tailpipe Test Failure.
- INSPECTION PROCEDURE 24: Purge Flow Test of the Evaporative Emission Canister Failure.
- INSPECTION PROCEDURE 25: Pressure Test of the Evaporative System Failure.
- INSPECTION PROCEDURE 26: Generator output voltage is low (approximately 12.3 volts)
- INSPECTION PROCEDURE 27: Incorrect Idle Speed When the A/C is Operating (A/C Switch 2 Signal)
- INSPECTION PROCEDURE 28: Fans (radiator fan, A/C condenser fan) are inoperative
- INSPECTION PROCEDURE 29: Power supply system and ignition switch-IG system.
- INSPECTION PROCEDURE 30: Fuel pump system.
- INSPECTION PROCEDURE 31: Ignition Switch-ST System. < M/T >
- INSPECTION PROCEDURE 32: Ignition Switch-ST System and Transmission Range Switch System. < A/T >
- INSPECTION PROCEDURE 33: Ignition Circuit System
- INSPECTION PROCEDURE 34: A/C system.