LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Fuel System - Except Coupe) >> Fuel Injection >> Throttle Position Sensor >> Installation >> Installation - 4 Cylinder

Installation - 4 Cylinder

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. The throttle shaft end of the throttle body slides into a socket in the TPS. The socket has two tabs inside it. The throttle shaft rests against the tabs. When indexed correctly, the TPS can rotate clockwise a few degrees to line up the mounting screw holes with the screw holes in the throttle body. The TPS has slight tension when rotated into position. If it is difficult to rotate the TPS into position, install the sensor with the throttle shaft on the other side of the tabs in the socket. Tighten mounting screws to 5.1 N.m (45 in. lbs.) torque.
    Fig 1: Idle Air Control Motor and Throttle Position Sensor
    G02328014Courtesy of DAIMLERCHRYSLER CORPORATION
  2. After installing the TPS, the throttle plate should be closed. If the throttle plate is open, install the sensor on the other side of the tabs in the socket.
  3. Attach electrical connector to the TPS.
  4. Install the negative battery cable.
scientia non olet · About LEMON Manuals