Removal - 2.7L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative cable from battery
Disconnect electrical connectors from throttle body (Fig 1).

Fig 1: TPS And Inlet Air Temp. Sensor 2.7L
Courtesy of DAIMLERCHRYSLER CORPORATION
Disconnect clean air hose from throttle body.
Remove the throttle cable shield (Fig 2).

Fig 2: Throttle Shield 2.7L
Courtesy of DAIMLERCHRYSLER CORPORATION
Hold throttle lever in wide open position. Remove throttle cable and speed control cables from throttle arm (Fig 3).

Fig 3: Throttle Cables 2.7L
Courtesy of DAIMLERCHRYSLER CORPORATION
Remove throttle cable bracket.
Remove the throttle body support bracket from the bottom of the throttle body (Fig 4).
Remove remaining 2 throttle body bolts (Fig 5).
Remove throttle body.
Clean mating surfaces.

Fig 4: Throttle Body Support Bracket 2.7L
Courtesy of DAIMLERCHRYSLER CORPORATION

Fig 5: Throttle Body 2.7L
Courtesy of DAIMLERCHRYSLER CORPORATION