LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Fuel System - Except Coupe) >> Fuel Injection >> Throttle Body >> Installation >> Installation - 4 Cylinder

Installation - 4 Cylinder

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install throttle body (Figure).
  2. Tighten throttle body mounting bolts to 13.6 N.m (120 in. lbs.) torque.
  3. Install the throttle cable bracket (Figure). Tighten throttle cable bracket mounting bolts to 14.1 N.m (125 in. lbs.) torque
  4. Hold throttle lever in the wide open throttle position and install the throttle and speed control cables (if equipped).
  5. Connect electrical connectors to the idle air control motor and throttle position sensor (TPS).
  6. Install the throttle cable shield.
  7. Install clean air hose to throttle body (Figure).
  8. Connect negative cable to battery cable.
scientia non olet · About LEMON Manuals