LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Fuel System - Except Coupe) >> Fuel Injection >> Idle Air Control Motor >> Removal >> Removal - 4 Cylinder

Removal - 4 Cylinder

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. Never use lubricants on O-rings or seals, damage may result.

  1. Disconnect negative cable from battery.
  2. Remove electrical connector from idle air control valve.
  3. Remove idle air control valve mounting screws (Figure).
  4. Remove motor from throttle body. Ensure the O-ring is removed with the valve.
scientia non olet · About LEMON Manuals