Installation - 4 Cylinder
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
When servicing throttle body components, always reassemble components with new O-rings (Fig 1) and seals where applicable.
- The new idle air control valve has a new O-ring installed on it.
- Carefully place idle air control valve into throttle body (Figure).
- Install mounting screw. Tighten screw to 4.5 N.m (40 in. lbs.) torque.
- Connect electrical connector to idle air control valve
- Connect negative cable to battery.