Installation - 4 Cylinder
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Before installing an injector the rubber O-ring must be lubricated with a drop of clean engine oil to aid in installation.
- Install injector clip by sliding open end into the top slot of the injector. The edge of the receiver cup will slide into the side slots of clip.
- Install injector top end into fuel rail receiver cap. Be careful not to damage O-ring during installation (Fig 1).
- Repeat steps for remaining injectors.
- Install the fuel rail, refer to INSTALLATION .