LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Fuel System - Except Coupe) >> Fuel Injection >> Fuel Injector >> Installation >> Installation - 2.7L

Installation - 2.7L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lightly lubricate the fuel injector O-rings with a couple drops of clean engine oil.
  2. Install fuel injectors.
  3. Install retaining clips on fuel injectors.
  4. Push injectors into fuel injector rail until clips are in the correct position.
  5. Position fuel rail over cylinder head, and push rail into place. Tighten fuel rail mounting bolts to 11 N.m (100 in. lbs.) torque.
  6. Connect fuel supply tube quick connect fittings at the rear of intake manifold. Refer to QUICK CONNECT FITTING .
  7. Connect electrical connectors to fuel injectors.
  8. Install intake manifold plenum. Refer to the appropriate Engine OVERHAUL article.
  9. Connect negative cable to battery.
scientia non olet · About LEMON Manuals