LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Fuel System - Except Coupe) >> Fuel Delivery >> Fuel Rail >> Removal >> Removal - 2.7L

Removal - 2.7L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: RELEASE FUEL SYSTEM PRESSURE BEFORE SERVICING FUEL RAIL. SERVICE VEHICLES IN WELL VENTILATED AREAS AND AVOID IGNITION SOURCES. NEVER SMOKE WHILE SERVICING THE VEHICLE.
  1. Release fuel system pressure. Refer to STANDARD PROCEDURE - FUEL SYSTEM PRESSURE RELEASE PROCEDURE .
  2. Disconnect the negative battery cable.
  3. Remove intake manifold plenum. Refer to the appropriate Engine OVERHAUL article.
  4. Remove intake manifold plenum mounting bolts. Lift Plenum up off of engine. Cover intake manifold to prevent foreign material from entering engine.
  5. Disconnect fuel supply tube quick connect fitting at the rear of the fuel rail. Refer to QUICK CONNECT FITTING .
  6. If the injector connectors are not tagged with their cylinder number, tag them to identify the correct cylinder (Fig 1).
    Fig 1: Injector Electrical Connectors
    G02327962Courtesy of DAIMLERCHRYSLER CORPORATION
  7. Remove electrical connectors from the fuel injectors.
  8. Remove mounting bolts on both sides of fuel rail.
  9. Lift fuel rail straight up off of cylinder head.
  10. Remove retaining clips from fuel injectors at fuel rail.
  11. Remove fuel injector from fuel rail.
scientia non olet · About LEMON Manuals