Remote Keyless Entry
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
The transmitter has four buttons for operation. They are LOCK, UNLOCK, DECK LID RELEASE, and PANIC.
- The UNLOCK
button will unlock the driver's door and enable illuminated entry. Pushing and releasing the button once will unlock the driver's door. Pushing and releasing the button two times, within a five second interval, will unlock all doors.
The unlock sequence can be toggled between driver door first and all door unlock functions.
- Upon pressing the LOCK button, the horn will sound a short CHIRP (if enabled) and flash the park lamps to notify that the all door lock signal was received and set. Illuminated entry is cancelled and the interior lamps are faded to off.
- DECK LID RELEASE - The Deck Lid release button changes from a default "press twice" actuation to a "press and hold" (for approximately one third of a second) default. Note that this is customer programmable to "no delay" if so desired.
- Pushing and holding the PANIC button will cause the panic alarm to sound for three minutes, until the panic button is pressed and held a second time, or the vehicle reaches a speed of 15 mph.
The receiver is capable of retaining a Vehicle Access Code (VAC) even when power is removed.
Each Remote Keyless Entry (RKE) module must have at least one and no more than four transmitters.