Automatic Door Locks
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
The BCM controls the power locks when the door lock switch is activated. If the door lock switch is pressed for longer than eight consecutive seconds, the BCM will de-energize the door lock relay.
The automatic door lock system can be enabled/disabled either by the customer or with the DRB III(R) scan tool. Refer to the DRB III(R) or the vehicle owner's manual for enabling/disabling procedures.
The BCM will automatically re-lock all doors if the above conditions are met and if any of the doors become ajar and then closes again.
The power latches are also equipped with a thermal protection system which prevents the latches from burning out.