LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Power Door Locks - Except Coupe) >> DECKLID Release Switch >> Removal

DECKLID Release Switch: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
  2. Remove left lower instrument panel cover.
  3. Disconnect the wire connector.
  4. Pinch four tabs around side of decklid release switch on the rear side of the left lower instrument panel trim, and push switch through opening.
scientia non olet · About LEMON Manuals