LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Power Door Locks - Except Coupe) >> DECKLID Release Solenoid >> Diagnosis And Testing - DECKLID Release Solenoid

Diagnosis And Testing - DECKLID Release Solenoid

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Confirm motor lead wire is connected and 10 volts or more are available at solenoid.
  2. Provide proper ground through latch mounting screws.
  3. Remove latch and examine plunger. Plunger should spring back when pressed.
  4. Insure that solenoid plunger travel is adequate approximately 16 mm (5/8 inch).
scientia non olet · About LEMON Manuals