Heated Seat Switch: Installation
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Be certain to install the switch in the correct orientation, drivers switch on the left and passenger on the right.
- Connect the center console wire harness connector on the connector receptacle on the back of the heated seat switch.
- Verify switch/system operation.
- Install the center console. Refer to INTERIOR/EXTERIOR - EXCEPT COUPE for the procedure.
- Install the heated seat switch in the center console mounting hole.
- Reconnect the battery negative cable.