LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Heated Seat System - Except Coupe) >> Heated Seat Element >> Diagnosis And Testing - Heated Seat Element >> Seat Cushion

Seat Cushion

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable. Disconnect the green 4-way heated seat wire harness connector. Using an ohmmeter, check for continuity between pins A and B of the seat cushion wire harness connector. See Fig 1. There should be continuity. If OK, test the seat back element as described below. If not OK, check the green 2-way seat cushion connector. If OK, replace the faulty seat cushion cover and element assembly.
Fig 1: Seat Cushion Element Connector
GC0032179Courtesy of DAIMLERCHRYSLER CORP.
1 - REAR VIEW OF HEATED SEAT SWITCH
scientia non olet · About LEMON Manuals