LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Manifolds >> Intake Manifold >> Removal & Installation >> Installation - Intake Manifold Upper

Installation - Intake Manifold Upper

  1. Clean and inspect sealing surfaces. Gaskets can be reused, if free of cuts or tears.
    NOTE: Make sure fuel injectors and wiring harnesses are in correct position to not interfere with upper manifold installation.
  2. Position upper manifold onto lower manifold. See Figure.
  3. Install manifold attaching bolts and tighten in sequence to 12 N.m (105 INCH lbs). See Figure.
  4. Tighten upper fastener at throttle body support bracket.
  5. Install EGR upper tube to manifold.
  6. Connect speed control servo, PCV , brake booster and vapor purge hoses.
  7. Connect electrical connectors to the following components:
    • Manifold Absolute Pressure (MAP)
    • Sensor Throttle Position Sensor (TPS)
    • Sensor Idle Air Control (IAC)
    • Motor Manifold Tuning Valve (MTV)
  8. Install throttle cable bracket.
  9. Connect throttle and speed control cables to bracket and throttle arm. Install throttle cable shield.
  10. Install throttle body air inlet hose and air cleaner housing assembly.
  11. Connect negative battery cable.
scientia non olet · About LEMON Manuals