LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Manifolds >> Exhaust Manifold >> Removal & Installation >> Removal - Rear Exhaust Manifold

Removal - Rear Exhaust Manifold

  1. Disconnect negative battery cable.
  2. Remove throttle body air inlet hose and air cleaner housing assembly.
  3. Remove bolts attaching EGR tube from exhaust manifold and EGR valve. Discard gaskets.
  4. Raise vehicle on hoist.
  5. Remove exhaust system from vehicle.
  6. Remove exhaust cross-under pipe.
  7. Remove rear catalytic converter.
  8. Disconnect and remove rear upstream oxygen sensor.
  9. Remove rear exhaust manifold heat shield.
  10. Remove exhaust manifold attaching bolts and remove manifold.
scientia non olet · About LEMON Manuals