LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Manifolds >> Exhaust Manifold >> Removal & Installation >> Installation - Rear Exhaust Manifold

Installation - Rear Exhaust Manifold

  1. Install exhaust manifold and gasket. Tighten bolts working from center outwards to 23 N.m (200 INCH lbs).
  2. Install rear catalytic converter and manifold heat shield. Tighten fasteners to 28 N.m (250 INCH lbs).
  3. Install oxygen sensor and connect electrical connector.
  4. Install exhaust cross-under pipe. Tighten fasteners to 28 N.m (250 INCH lbs)).
  5. Install exhaust system. Tighten fasteners to 28 N.m (250 INCH lbs).
  6. Lower vehicle.
  7. Install EGR tube using new gaskets. Tighten screws to 11 N.m (95 INCH lbs).
  8. Install throttle body air inlet hose and air cleaner housing assembly.
  9. Connect negative battery cable.
scientia non olet · About LEMON Manuals