LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Engine Mounting >> Right Mount >> Removal & Installation >> Removal

Removal & Installation: Removal

  1. Remove coolant pressure container.
  2. Remove heater tube front attaching screw.
  3. Raise vehicle on a hoist and remove inner splash shield.
  4. Remove heater tube rear attaching screw.
  5. Remove the right engine support assembly vertical fasteners from frame rail.
    Fig 1: Removing Right Side Engine Mount
    G00385981Courtesy of CHRYSLER CORP.
  6. Lower vehicle. Remove the load on the engine motor mounts by carefully supporting the engine assembly with floor jack and wooden block on oil pan.
  7. Remove the bolts attaching the engine support assembly to the engine bracket. See Fig 1.
  8. Remove right engine mount.
scientia non olet · About LEMON Manuals