LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Engine Mounting >> Rear Mount >> Removal & Installation >> Installation

Removal & Installation: Installation

  1. Position rear mount on suspension crossmember and loosely install bolts.
  2. Position mount bracket on transaxle and install bolts. Tighten to 95 N.m (70 ft. lbs).
  3. Tighten rear mount to crossmember bolts to 61 N.m (45 ft. lbs).
    CAUTION: Be sure the weight of the engine is static and in rest position.
  4. Install rear mount to bracket through bolt and tighten to 75 N.m (55 ft. lbs).
  5. Tighten front mount through bolt to 75 N.m (55 ft. lbs).
  6. Lower vehicle. Install throttle body air inlet hose and air cleaner housing assembly.
scientia non olet · About LEMON Manuals