LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Engine Block >> Vibration Damper >> Removal & Installation >> Installation

Removal & Installation: Installation

  1. Install damper using Special Tools 8179 Screw, with Nut and Thrust Bearing from 6792, and 6792-1 Installer.
    Fig 1: Installing Vibration Damper
    G00385977Courtesy of CHRYSLER CORP.
  2. Install damper center bolt. Tighten center bolt to 170 N.m (125 ft. lbs).
  3. Install accessory drive belts.
  4. Install belt splash shield and right front wheel.
  5. Lower vehicle.
  6. Connect negative battery cable.
scientia non olet · About LEMON Manuals