LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Cylinder Head >> Valve Springs >> Removal & Installation >> Installation (In Vehicle)

Installation (In Vehicle)

  1. The valve stem seal/valve spring seat should be pushed firmly and squarely over the valve guide using the valve stem as guide. Do Not Force seal against top of guide. When installing the valve retainer locks, compress the spring only enough to install locks.
  2. Follow the same procedure on the remaining cylinders using the firing sequence 1-2-3-4-5-6. Make sure piston is at TDC on the cylinder that the valve spring is to be removed.
  3. Remove spark plug adapter tool and Special Tool MD 998772A.
  4. Install rocker arm(s).
  5. Install camshafts. See CAMSHAFT .
  6. Install cylinder head covers. See CYLINDER HEAD COVER - LEFT  and CYLINDER HEAD COVER - RIGHT  .
  7. Install upper intake manifold. See INTAKE/EXHAUST VALVES & SEATS .
  8. Install air cleaner housing and inlet hose.
  9. Connect negative cable.
scientia non olet · About LEMON Manuals