LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Cylinder Head >> Rocker Arms >> Removal & Installation >> Installation

Removal & Installation: Installation

  1. Lubricate rocker arms with clean engine oil before installation.
  2. Rotate engine until cam lobe is on its base circle (heel) of rocker arm being installed.
  3. Using Special Tools 8215-A and 8216-A Adaptor, depress valve spring only enough to install rocker arm. See Figure.
  4. Install rocker arm in original position (if reused) over valve and lash adjuster. Release tension on valve spring.
    NOTE: Inspect rocker arm for proper engagement into lash adjuster and valve tip.
  5. Repeat procedure for each rocker arm being installed.
  6. Install cylinder head cover(s). See CYLINDER HEAD COVER - LEFT  and CYLINDER HEAD COVER - RIGHT  .


  1. Lubricate rocker arms with clean engine oil before installation.
  2. Rotate engine until cam lobe is on its base circle (heel) of rocker arm being installed.
  3. Using Special Tools 8215-A and 8216-A Adaptor, depress valve spring only enough to install rocker arm. See Figure.
  4. Install rocker arm in original position (if reused) over valve and lash adjuster. Release tension on valve spring.
    NOTE: Inspect rocker arm for proper engagement into lash adjuster and valve tip.
  5. Repeat procedure for each rocker arm being installed.
  6. Install cylinder head cover(s). See CYLINDER HEAD COVER - LEFT  and CYLINDER HEAD COVER - RIGHT  .
scientia non olet · About LEMON Manuals