LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Electrical >> Component Locations >> Electrical Component Locator - Convertible >> Sending Units & Sensors

Sending Units & Sensors

SENDING UNITS & SENSORS LOCATION

Component Location
A/C Evaporator Temperature Sensor On right side of HVAC housing.
Ambient Temperature Sensor On rear side of front bumper beam.
Camshaft Position (CMP) Sensor On front of left cylinder head. See Figure .
Crankshaft Position (CKP) Sensor On rear of engine. See Figure .
Engine Coolant Temperature Sensor Near thermostat housing. See Figure .
Heated Oxygen Sensor (Left Bank Front) On left exhaust pipe, before catalytic converter.
Heated Oxygen Sensor (Left Bank Rear) On left exhaust pipe, after catalytic converter.
Heated Oxygen Sensor (Right Bank Front) On right exhaust pipe, before catalytic converter.
Heated Oxygen Sensor (Right Bank Rear) On right exhaust pipe, after catalytic converter.
Input Speed Sensor (A/T) On left side of torque converter housing. See Figure .
Intake Air Temperature (IAT) Sensor In air duct, near throttle body.
Manifold Absolute Pressure (MAP) Sensor On intake manifold plenum. See Figure .
Output Speed Sensor (A/T) On left side of transmission case. See Figure .
Throttle Position Sensor On throttle body. See Figure .
Transmission Range Sensor On left side of transaxle. See Figure .
Wheel Speed Sensor (Left Front) On left front steering knuckle boss.
Wheel Speed Sensor (Rear) (2) On respective rear brake support plate.
Wheel Speed Sensor (Right Front) On right front steering knuckle boss.