LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System - TEVES Mark 20 - Except Coupe >> Component Tests >> Proportioning Valve >> JR Body

JR Body

  1. Road test vehicle to determine which rear wheel indicates a premature wheel skid. Remove suspect proportioning valve from brakeline.
  2. Remove brake flex hose mounting bracket from frame rail so brakelines will not be bent when installing proportioning valve with adapters back into vehicle.
  3. Install Adapter (8187-2) into outlet port of proportioning valve. Install proportioning valve with adapters back into vehicle.
  4. Install Pressure Gauge (C-4007-A) into each adapter. Bleed air from pressure gauges. Have an assistant hold brake pedal down until pressure on inlet side of proportioning valve is 1000 psi (70 kg/cm2 ) and note pressure on outlet side of proportioning valve. Pressure on outlet side should be 600-700 psi (42-49 kg/cm2 ). Replace proportioning valve if pressure is not within specification.
  5. Remove test equipment. Reinstall brakelines on proportioning valve. Tighten brakeline nuts to 12.5 ft. lbs. (17 N.m). Bleed brake system. See BLEEDING BRAKE SYSTEM  . Once brake system is bleed, perform pressure test on remaining proportioning valve.
scientia non olet · About LEMON Manuals