Park Brake Lever: Removal
- Remove the floor console. See CENTER CONSOLE .
- Lower park brake lever handle. Loosen adjusting nut on park brake lever output cable. See Figure . This will take tension off output cable, allowing it to be easily removed from tension equalizer.
- Using a screwdriver, unlatch the park brake output cable retainer, then remove cable retainer from park brake cable tension equalizer. See Figure . Remove the park brake cable tension equalizer from the park brake lever output cable.
- Remove the electrical connector from the ground switch on the park brake lever mechanism. Unclip the wiring harness from the park brake mechanism bracket.
- Remove the 4 bolts attaching the park brake lever mechanism bracket. See Fig 1 . Remove the park brake lever mechanism from the vehicle.
CAUTION:
Discard output cable retaining clip after removing it from park brake cable tension equalizer. Retainer is not to be re-used, a NEW retainer is to be installed when attaching output cable to tension equalizer.