LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes - Except Coupe >> Removal & Installation >> Master Cylinder >> Installation

Master Cylinder: Installation

  1. Position master cylinder assembly on studs of power brake unit, aligning push rod on power brake vacuum booster with piston of master cylinder.
  2. Install the 2 master cylinder to power brake vacuum booster mounting nuts. Tighten both nuts to specification. See TORQUE SPECIFICATIONS  .
  3. Connect brake tubes to master cylinder primary and secondary ports. Then tighten the tube nuts to specification.
  4. Connect wiring harness connector to brake fluid level switch. Fill master cylinder with clean, fresh Mopar(R) Brake Fluid.
  5. Road test vehicle to ensure proper operation of brakes.
scientia non olet · About LEMON Manuals