Park Brake Cable
These vehicles uses a bent nail type park brake cable tension equalizer. See Fig 1 . The bent nail tension equalizer is to be used only one time to set the park brake cable tension. If the park brake cables require adjustment during the life of the vehicle, a NEW tension equalizer MUST be installed before doing the park cable adjustment procedure.
- Remove the center floor console. See CENTER CONSOLE under REMOVAL & INSTALLATION.
- Lower park brake lever handle. Loosen adjusting nut on park brake cable output cable. This will take tension off output cable, allowing it to be easily removed from tension equalizer. See Fig 2 .
- Using a screwdriver, unlatch the park brake output cable retainer. See Fig 3 . Then remove cable retainer from park brake cable tension equalizer. Remove the park brake cable tension equalizer from the park brake lever output cable and the rear park brake cables. See Fig 4 .
- Install a NEW park brake cable tension equalizer on the park brake lever output cable and rear park brake cables.
- Install a NEW park brake lever output cable to tension equalizer retaining clip on tension equalizer. See Fig 5 . The cable retainer must be closed and securely latched.
- Adjust cable tension for the park brake system using the following steps:
- Position park brake lever so it is in the fully released position.
- Tighten the adjusting nut on the park brake lever output cable until 26 millimeters of thread is out past top edge of adjustment nut. See Fig 6 .
- Actuate the park brake lever to its fully applied position one time (15 clicks) and then reposition the lever to its fully released position.
- Check the rear wheels of the vehicle, they should rotate freely without dragging. After the park brake cable tension has been properly adjusted, check for free play in park brake lever. Park brake hand lever should feel firm at all clicks, with a maximum of 15 clicks of lever travel possible.
- Install the center floor console. See CENTER CONSOLE under REMOVAL & INSTALLATION.
CAUTION:
Discard output cable retaining clip after removing it from park brake cable tension equalizer. DO NOT re-used retainer, a NEW retainer is to be installed when attaching output cable to tension equalizer.
CAUTION:
A NEW cable tension equalizer MUST be installed when adjusting park brake cable tension.
CAUTION:
A NEW park brake lever output cable retainer must be used when installing output cable on cable tension equalizer. Cable retainer usage is required to ensure output cable can not separate from tension equalizer.
NOTE:
Actuating the park brake lever to its fully applied position one time after tightening the adjustment nut will yield (stretch) the bent nail portion of the tension equalizer approximately 1/4". This process will correctly set the park brake cable tension.