LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Body & Frame >> Power Windows - Except Coupe >> Removal & Installation >> Window Regulator >> Removal & Installation (Rear Window Regulators - Sebring Convertible)

Removal & Installation (Rear Window Regulators - Sebring Convertible)

  1. Raise window to up position, if possible. Remove quarter trim panel. See QUARTER TRIM PANEL (SEBRING CONVERTIBLE)  . Disconnect quarter window motor electrical connector. Remove nuts attaching quarter window regulator to vehicle.
  2. Remove quarter window regulator from vehicle by lifting upward through opening at top of quarter panel. Remove nuts securing window glass to regulator. Remove latch plate hook nut and remove glass. To install, reverse removal procedure.
  3. Immediately after installation and before operation of window, adjustment is necessary for proper operation and sealing of window. This also ensures window is not damaged by convertible top or front door window glass. See REAR WINDOW  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals